ContactContact Us

Zhejiang Shanhai Machinery Co., Ltd

Tel: 13905700574

Landline: 0570-8588906

                0570-8588900

Email: ryan74853@163.com

Address: No. 56, Donggang Third Road, Quzhou, Zhejiang

web:en.shjxcomp.com

Your current location : Home >> News >> Company news

Cold wind invasion muscle! How to maintain permanent magnet screw air compressor in winter?

2020-12-07 02:04:34
a

100 spring cold all swallow, I sing cold more cut, this is from the Tang dynasty poet Liu Jia exclamation! In the cold winter, our ancestors are complaining that the weather is really cold, and we are not, in our own warm at the same time, how should we give our permanent magnet screw air compressor "add clothes warm"?

永磁螺杆式空压机

1. The influence of cold on air compressor


The temperature difference between day and night in winter is relatively large, and it is necessary to put condensed water. If it is not discharged in time, it is likely to freeze and crack the equipment in the air compressor at night. When the cold air enters the air compressor, it will produce a lot of water vapor at high temperature, which will increase the burden of air compressor processing water vapor filtration. Therefore, we suggest that users must pay attention to empting all gases, sewage discharge and water discharge in order to normal use of the air compressor after shutdown and cooling in winter.


2. About the oil level


Before the air compressor is used, open the side plate to check whether the air compressor oil is thickened and frozen. If so, the oil must be heated to keep the lubricating oil in the oil pool within the scale range. Before the operation of the air compressor, the oil quantity in the oiler should not be lower than the scale line value.


3. Professional oil for air compressor


The base oil used for compressor oil requires the following performance requirements: the base oil fraction should be narrow, the flash point should be appropriate, to ensure the safety of use at the same time, reduce the generation of carbon deposition and oil loss; Good thermal and oxygen stability to ensure good sediment control; Sufficient viscosity and temperature performance to ensure the stability of oil film; Sufficient flow performance to reduce start-stop and extreme temperature wear, while also cooling the effect to a certain extent.

4. Downtime time and space press management


After the compressor is shut down, the gas must be discharged to the monitor to display 0.0bar before closing the valve. Open the automatic drainage valve of air compressor, air storage tank and dryer. Make the air and condensate water completely empty after closing.

Long time shutdown, must start once a week, 3 hours later to repeat the above operation.


In cold and low temperature weather, we should always pay attention to the operation of air compressor, do a good job of regular maintenance and maintenance, prevent the occurrence of air compressor failure, to ensure the smooth progress of production.


Keep the environment clean and tidy, especially pay attention to the ground around the air compressor without water, to prevent icing and sliding, resulting in operator falls.


Only by mastering the above four steps will the air compressor not be afraid of the cold winter!








Contact

Zhejiang Shanhai Machinery Co., Ltd

Tel: 13905700574

Landline: 0570-8588906

                0570-8588900

Email: ryan74853@163.com

Address: No. 56, Donggang Third Road, Quzhou, Zhejiang

WeChat official account

technical support:易企推
  • Home
  • Phone
  • Return